Custom made in the USA bits to open up your Microtech Knife.

Just because Microtech doesn’t want you to open up your knife doesn’t mean that you can not now.

THESE ARE AFTERMARKET TOOLS DESIGNED TO FIT MICROTECH KNIVES

THEY ARE SUPERIOR TO ANYTHING THAT IS CURRENTLY AVAILABLE FOR SALE

THEY ARE USA MADE !!!!

Need to do minor maintenance or replace springs and parts on your Microtech, now you can.

Fits Medium Size Screws Which Have Curved Coned Heads

THIS MEANS THEY ARE NOT FLAT, THIS MEANS THEY TAPER UP TO A CONE

IF YOU DON’T KNOW WHAT A CONE IS GOOGLE CONE HEAD BECAUSE THAT IS YOU.

Medium Tri-Bit Measurements:

Separation of Holes = 0.10" (7/64") (2.7mm)

Base Height = 0.09" (3/32) (2.44mm)

(Measurements are across the outside of the holes)

Typically Fit the UT-X85, Ultratech, Scarab, Troodon, and HALO

Tri-Bit Wrenches are built with ¼” hex ends and can be dropped into a standard size hex end screw driver handle.

A short driver is recommended to avoid shearing the screws.

If you encounter a tight screw, it may have thread locker on it.

To loosen up Loctite aka tread locker you can:

1.  Use a heat gun

2.  Use the tip of a soldering iron and touch the screw heads

3.  Place the knife in the oven at 250 degrees. (Only if it has solid metal construction, meaning no handle scales)

SALES ON TRI-BIT TOOLS ARE FINAL - NO EXCHANGES- NO NOTHING.

THAT MEANS YOU GET OFF YOUR LAZY ASS AND MEASURE THE SCREWS YOURSELF WITH A MIC OR DIAL CALIPER OR HOWEVER YOU WANT TO DO IT.

Microtech replacement parts and components are not authorized, affiliated with, or sanctioned by Microtech.